liquid6Silo

SILO USER GUIDE

Included

Micro USB Charging Cable Illustration
510 Thread Magnetic Adapters Illustration
Liquid6 Silo Power Supply

USB to Micro USB Cable

510 Magnetic Adapters

Silo Power Supply

Included

Micro USB Charging Cable Illustration

USB to Micro USB Cable

510 Thread Magnetic Adapters Illustration

510 Thread Magnetic Adapters

Liquid6 Silo Power Supply

Silo Power Supply

Product Use

Installing the Cartridge

Twist the 510 Cartridge clockwise onto Magnetic Adapter (included) until snug. Do not overtighten. Slide the Cartridge into Power Supply until the magnet snaps into place.

To avoid residue buildup, remove the Cartridge from the Power Supply when not in use by twisting the Cartridge 360º before pulling it from the device. Clean the Cartridge and Power Supply contact pins after every 10-15 activations.

Activating Vaporizer

Inhale on Cartridge mouthpiece to activate the Power Supply. The LED will illuminate to indicate activation. To avoid residue buildup, remove the Cartridge from the Power Supply when not in use by twisting the Cartridge 360º before pulling it from the device. Clean the Cartridge and Power Supply contact pins after every 10-15 activations.

Charging Power Supply

Insert the included Micro USB to the bottom of the Palm Power Supply, then connect the USB to a power adapter or active USB port (not included). For the best performance, charge the Power Supply often after use. While the Power Supply is charging, the small LED at the top of the device will light up and remain lit. Once the device reaches a full charge, the LED will flash 20 times and then turn off. If the device is plugged into an active USB port or wall adapter and the light is not lit, it has a full charge.

Depleting Cartridge

Cartridge is empty when vapor is no longer produced after activation. Due to headspace, the cartridge may still produce vapor after the reservoir appears empty because of out of view oil absorbed in the atomizer. Learn More

Cleaning Device

Remove the Cartridge from the Power Supply. Use a cotton swab dampened with diluted isopropyl rubbing alcohol to clean the exterior of the Cartridge, Power Supply, and contact points.
Previous slide
Next slide

Product Use

Installing the Cartridge

Twist the 510 Cartridge clockwise onto Magnetic Adapter (included) until snug. Do not overtighten. Slide the Cartridge into Power Supply until the magnet snaps into place.

To avoid residue buildup, remove the Cartridge from the Power Supply when not in use by twisting the Cartridge 360º before pulling it from the device. Clean the Cartridge and Power Supply contact pins after every 10-15 activations.

Activating Vaporizer

Inhale on Cartridge mouthpiece to activate the Power Supply. The LED will illuminate to indicate activation. To avoid residue buildup, remove the Cartridge from the Power Supply when not in use by twisting the Cartridge 360º before pulling it from the device. Clean the Cartridge and Power Supply contact pins after every 10-15 activations.

Charging Power Supply

Insert the included Micro USB to the bottom of the Palm Power Supply, then connect the USB to a power adapter or active USB port (not included). For the best performance, charge the Power Supply often after use. While the Power Supply is charging, the small LED at the top of the device will light up and remain lit. Once the device reaches a full charge, the LED will flash 20 times and then turn off. If the device is plugged into an active USB port or wall adapter and the light is not lit, it has a full charge.

Depleting Cartridge

Cartridge is empty when vapor is no longer produced after activation. Due to headspace, the cartridge may still produce vapor after the reservoir appears empty because of out of view oil absorbed in the atomizer. Learn More
Previous slide
Next slide

FAQ

Frequently Asked Questions

Cartridge

Jupiter Research partners with licensed extractors, growers, and producers that fill, seal, and deliver Liquid6™ Cartridges to licensed retailers.

No. Liquid6™ Cartridges are designed for single-use only.

It depends. Many variables affect how many activations an individual cartridge can provide. Factors include the duration of inhalation and the type of plant-derived extract.

Our cartridges vaporize oil at a consistent rate of 5mg per 3-second draw. Based on this level of consumption, a 0.5mL cartridge would last about 100 draws.

  1. Cartridge is empty when vapor is no longer produced after activation. Due to headspace, the cartridge may still produce vapor after the reservoir appears empty due to out of view oil absorbed in the atomizer.

  1. All cartridges may leak when transported from a lower elevation to a higher elevation. The degree of leakage depends on how full the cartridge is, how large the increase in elevation is, and the speed at which the elevation changes.

    To prevent leakage, store the cartridge with the mouthpiece pointing downward.

U.S. Federal Aviation Regulations dictate transport or use of substances and pharmaceuticals. Visit the Federal Aviation Administration website for more information.

Power Supply

For the best Silo performance, prevent condensation by keeping the contact pins inside the device and on the bottom of the cartridge clean and dry.

  1. Remove the Cartridge from the Power Supply.
  2. Use a cotton swab dampened with diluted isopropyl rubbing alcohol to clean the contact points.
  3. Allow contact pins to dry thoroughly before use.
    • Avoid dropping the device.
    • Avoid exposure to moisture.
    • Do not attempt to repair or modify the device.

The vaporizer will no longer activate when the Power Supply needs recharging. If the device is plugged into an active USB port or wall adapter and the light is not lit, it has a full charge.

While Silo is charging, the small LED at the top of the device will light up and remain lit. Once the device reaches a full charge, the LED will flash 20 times and then turn off.

Jupiter products are sold to wholesale brands that carry their products in Dispensaries and retailers across the world. Silo packaging features visible Jupiter and CCELL® branding.

  1. All Jupiter Research vaporizers shut off after 10 seconds of inhalation.

  1. Silo uses a standard 510 thread that is used on cartridges industry-wide. Although these considerations have been made, we cannot guarantee Silo is compatible with every cartridge available in the market.

All Li-ion battery cells used in Jupiter products meet the requirements of UN38.3, ensuring they are safe for air transportation.  All Jupiter products include short-circuit protection that disables the output if a short is detected. Rechargeable products include on-board charging control to protect the cell from overcharging if they are accidentally charged with an adapter from another brand.

U.S. Federal Aviation Regulations dictate transport or use of batteries, substances, and pharmaceuticals. Visit the Federal Aviation Administration website for more information.

Contact Our Team