Learn how to fill and cap your Infinity™
Filling the ReservoirFill a syringe with a short, blunt tipped needle (14 ga. or smaller) with oil. Insert the needle into the space between the airway and the outer walls of the reservoir. Fill both sides of the reservoir with 0.5mL/1.0mL of oil (0.25mL/0.5mL on each side).
Note: The syringe and needle may need to be warmed to improve fluid.
Do not allow fluid to enter the airway (center tube) as it may cause a short circuit.
Capping the DevicePlace the mouthpiece on top of the device, align it to the device walls, and press the mouthpiece down until proper closure.
Failure to install the mouthpiece within 1 minute of filling may result in leakage.
Allow For HeadspaceCheck that the mouthpiece is pressed in completely and properly. Device should be allowed to stand for at least 30 minutes before use. During this time, fluid is priming the atomizer. The rate that the atomizer saturates is dependent upon the viscosity of the fluid. More viscous fluids may require more time.
If the device is to experience a pressure change as a result of an increase in temperature or a change in elevation, the device must be shipped with the mouthpiece facing down, allowing for the inlets to be exposed to ambient air.