Dip a heat resistant container with oil into a Thermostatic Water Bath or a bowl of hot water for at least 30 seconds or until oil reaches low viscosity (similar to a liquid).
Gently pull the syringe cap off and attach blunt tip needle. Holding the syringe with the needle pointing down, dip the syringe in the oil.
Pull back the plunger and fill with oil to the 1.0mL line on the syringe.
Holding the syringe cap, dip the plunger with concentrate into a cup of hot water for at least 30 seconds or until oil reaches low viscosity (similar to a liquid).
Once warmed, gently pull the syringe cap off and attach the blunt tip needle.
Insert the blunt tip needle into the reservoir between the airway and the outer wall of the cartridge. With the cartridge held upright, press the syringe plunger to fill reservoir with a measured 1.0mL of oil.
Immediately after filling, install the mouthpiece and twist clockwise to a finger-tight fit. The mouthpiece is set when the bottom seal sits inside the glass housing. Do not over-tighten.
Cartridges should stand for at least 30 minutes before use to allow the atomizer to saturate. More viscous fluids require more time.
No. Our devices are not to be used for tobacco derived products.
The Jupiter line of products are sold to wholesale brands who carry their products in Dispensaries and online retailers across the world.
Our cartridges vaporize oil at a consistent rate of 5mg/3 seconds (one pull). At this level of consumption, a 0.5mL would last 100 pulls.
No. Jupiter cartridges are designed for single use only.
Device is empty when vapor is no longer produced after activation. Cartridge may still produce vapor after it appears "empty" because of headspace. Learn More. The Power Supply is depleted when the light tip flashes 3 times upon activation, instead of staying lit for the entire activation duration.
At this time we do not sell directly to consumers.
Jupiter cartridges are designed for single use, only. They are filled by the extractor/processor that produced the extract and sealed before delivery to the retailer.
All Li-ion battery cells used in Jupiter products meet the requirements of UN38.3, ensuring they are safe for air transportation. All Jupiter products include short-circuit protection that disables the output if a short is detected. Rechargeable products include on-board charging control to protect the cell from overcharging if they are accidentally charged with an adapter from another brand.
At Jupiter Research we have done our best to develop cartridges compatible with as many batteries as possible. We use a standard 510 thread and include two air flow paths in the base; one for breath actuated batteries and one for button actuated batteries. Although these considerations have been made, we cannot guarantee our cartridges are compatible with every battery available on the market today or the in the future.
All cartridges may leak when transported from a lower elevation to a higher elevation. The degree of leakage depends on how full the cartridge is, how large the increase in elevation, and how rapidly the elevation change. To prevent leakage, store the cartridge inverted, with the mouthpiece pointing downward during large elevation changes or air travel.
Federal Aviation Laws dictate transport or use of legal and illegal substances and pharmaceuticals. Visit the FAA website for more information. Travel at your own risk.